Glaco Windshield Coating Agent and Wiper Series
Wiper Type

Glaco Wiper Super Water Repellent

Stable wiping, forming strong water-repellent layer!

  • Content : 1pc

Technology of "Glaco Wiper Super Water Repellent"

Condensed Glaco component is impregnated in silicone rubber.
Only operate with this wiper, forms strong water-repellent layer on windshield surface, and provides you clear visibility.
Rubber is coated by newly developed graphite, to diminish unpleasant squeaking of wiper.
In addition, if you use this wiper for Glaco coated windshield, it restores coating layer and improves durability of water-repellent effect.

Only by wiping, makes Glaco coating

Only by wiping, makes Glaco coating

Just by turning on this wiper on dry windshield, you can get almost same effect as Glaco applying.

Creates water-repellent layer

Creates water-repellent layer

Although conventional wiper requires wiping for 5 min on dry condition in order to form coating layer, Glaco Power Blade forms water-repellent layer in half of time (about 2 min, according to our test).

Newly developed "S・L・F Coat" enables sharp wiping

Newly developed "S・L・F Coat" enables sharp wiping

In order to improve low frictionality of graphite, wiper rubber is coated with newly developed "Super Low Frictional Coat" with fluoric resin. Diminishes unpleasant squeaking of wiper, and enables sharp and smooth wiper operation.

How to use "Glaco Wiper Super Water Repellent"

General timing of replacing wiper rubber

  • Wiper rubber is expendable item. When you conscious of jumping or squeaking, recommended to replace wiper rubber.
Pull up wiper arm.

Pull up wiper arm.

Pull up the wiper arm to stand, and turn the blade so that wiper rubber comes to upside.

The cars with wipers hidden under bonnet, check the car manual and work in accordance with its instruction.

Detach blade.

Detach blade.

You can work easier if you detach blade. Push the stopper pin at the connector, and slide the blade to remove.

After removing blade, recommended to lay down the arm for avoiding damage to windshield by unexpected flopping.

Pull the old rubber and remove it from the blade.

Pull the old rubber and remove it from the blade.

Grip the rubber on the side which has stopper, and pull out it from the blade.

Insert the new rubber.

Insert the new rubber.

Insert the new rubber on the edge without locking gap, into the blade through the rail.

Set the stopper of rail into the locking gap.

Set the stopper of rail into the locking gap.

Push the rubber till the rail stopper will penetrate into the locking gap.

Reset the blade on wiper arm.

Reset the blade on wiper arm.

Return the blade on the wiper arm as inverse process. Make sure that the connector pin will steadily get hooked in wiper arm.

After work, make sure that the wiper works normally, to be safe.

  1. Glaco - TOP
  2. Products : Wiper Type
  3. Glaco Wiper Super Water Repellent

All Wiper Type